Description

Crown ultraguard protect silicone extreme is a Premium quality emulsion based on German Silicone Technology preferred by leading architects worldwide.

Uses: It is suitable for new, previously painted plaster, cement, brick, stone and many other surfaces including soft-board and hardboard ceilings and walls, asbestos sheets.

Advantages:

• Visible water repellency effect.
• Fully breathable.
• Dirt repellent.
• Excellent opacity.
• Easy to apply-no special application or equipment needed.
• Rapid drying i.e. one can apply two coats the same day.
• Can be applied on all types of surfaces subject to normal preparation.
• A waterborne system and is odour free.
• Wide colour range.
• Long term protection; the life expectancy of 15 years.
• Reduced maintenance costs.
• Tested and qualifies the efficacy at well-known international laboratories.
• Suitable for almost all architectural structures like exterior masonry.
• Crack bridging for hairline cracks up to 1mm.

Conditions during application: The temperature of the substrate should be minimum 10°C and at least 3°C above the dew point of the air, measured near the substrate. Good ventilation is required in confined areas to ensure proper drying.

PRODUCT DATA

Colour Range: Available in a range of over 11,000 colours from Ambiance Plus, RAL, BS 4800 and various colour charts through the dispensing system.

Pack Sizes: 1 Litre, 4 Litres and 20 Litres

Finish: Matt

Thinner & equipment cleaner: Water

Dilution Ratio: Maximum 15% by volume with water. Avoid over-thinning as this will affect the opacity. Stir well before use.

Drying Times: Surface dry 1-hour max & Hard dry after 4 hours max.

APPLICATION DATA

The product can be applied by brush, roller or airless spray.

Spreading Capacity per coat: Depends on film thickness applied, type of texture, surface porosity, imperfections, temperature & wastage during the painting 12 – 14 m²/l.

The spread rate can be reduced to as low as 2m²/L on roughcast plaster.

Maximum spread rate per coat is obtained at minimum dry film thickness and vice versa.